Die Sets & Components
We offer a full line of precision catalog die sets & components, you specify the bushing and pin style. Special die sets are also available.
- Press Fit Guide Pins
- Demountable Guide Pins
- PRODUCTO Steel Bushings
- Bushing shoulder ground square to press fit diameter assists in obtaining correct alignment when properly seated against ground surface of punch holder
- Ground lead on press fit end starts bushing accurately into punch holder
- Lubrication fitting at intersection of double figure-eight grooves allow for simple, effective lubrication
- A nominal allowance is provided on the inside diameter for honing after assembly
- Demountable Shoulder Bushings
- Ball Bearing Pins
- Made from chrome alloy steel, hardened
- Ground to a high degree of tolerance accuracy
- Complete interchangeability, not only with our own but other manufacturers’ also
- Ball Bearing Bushings
- Made from vacuum degassed chrome alloy steel, hardened
- Ground and honed to exacting tolerance limits
- Interchangeable and do not require select fitting
- Ball Bearing Retainers
- Made with an optimum number of selected steel ball bearings and a rugged alloy sleeve, these retainers assure accurate die alignment and long life
- The balls are dimensioned for a preload rolling fit and arranged in a helical pattern so each ball has a separate linear path
- A set screw keys the retainer to a slot in the guide pin
- Series 500 Assemblies
- Series 500 Ball Bearing Assemblies are designed for the pin to be installed in the die shoe
- All components are manufactured to the highest levels of quality and precision
- Bushings are precision ground on both ID and OD to close tolerances
- All assemblies use plain bearing press fit guide pins
- Agathon
- Bushings
- Ball Cages
- Pillars
- Roller Cages
- Catalog Die Sets
- Rear 2 Pin Die Sets
- Foot Press Die Sets
- Special Die Sets
- Many styles and sizes available to meet your die set needs
- Manufactured from A-36 hot rolled steel or aluminum plates
- All plates are stress relieved up to 23” with flame cut edges and ground to clean up unless otherwise specified
- Available with your choice of plain bearing or ball bearing components
- We have the capability to add bolt holes, milled pockets, torch cut burn outs and handling holes, or other machining your application requires (Prints are required for additional machining and must be specified when ordering)
